Good tips, thanks.
Righto, followed squirrelman’s advice and used a bolt in the master cylinder to see if it was holding pressure. Sadly no, no it wasn’t. Pulled the...
Thanks squirrelman this will be on my list too.
Thanks guys, I do have a vacuum bleeder, I called it a compressed air bleeder in my post which may have been confusing. I also forgot to mention...
I have dismantled the slave, seal looks good. I have dismantled the lever, removed the rubber boot and rod, all looks good. I was going to remove...
Thanks Roccoaster, I gave it a try but no luck. Does anyone know if it possible for the master cylinder plunger seal to let air into the system...
Hi everyone, I too am having trouble bleeding the clutch on my ‘95, I have followed all the tips in this thread and still no clutch. I have bleed...
Ok, another update. The brand new cam arrived from the Netherlands to Australia in 7 days , but I waited for the second hand cam from the States,...
Hi all, my new cam arrived and I wanted to get some advice before I go trying to put it all back together. In the photos attached below, i have...
Gday Brooksy, I just bought a 4th Gen a few weeks ago. Got back on the bikes 3 years ago after an 18 year absence. I’m in Warrnambool.
Squirrelaman, I honestly can’t say if I did or didn’t rotate the crank when the cam was out, although I am 99% confident that I didn’t. After...
So, Honda Australia told me these cams are no longer in production, and there is no stock available. I found one cam in the Netherlands at CMS,...
I was not using a torque wrench at that point, I had previously tightened down the cam holders using my 1/4” 10mm socket and when the caps reach...
Well, massive f-up from me last night, I was completing the valve shims, buttoned up the rear inlet cam, re-checked and needed to replace one of...
The bike has 45k miles, 73k km’s on it. I’ll pull the head stem and check, but looks like I might be up for bearings too.
One of my needles did have a suspect area though where it has worn very shiny, there is no discernible indentation on the needle though. [ATTACH]
Thanks guys, I don’t know how I missed that in the manual. I have buttoned the carbies back up and am waiting on my insulators before I can...
I have read on here posts by @Squirellman that they are not adjustable. I have just had my carbs apart, and there is no adjusting tang.
New jets, gaskets, bowl drain screws. Gave everything a nice clean before re-assembly. Hooked up the drip, no leaks. Waiting on the new...
Thanks squirrelman.
Separate names with a comma.
