You're half right - Rt 16 is nice from Milan to Errol (Rt 26 intersection) but it's a rough road north of Errol, which wouldn't be too bad except...
One of the simplest, easiest things to do to prevent a bad ground on these bikes is to solder the entire ground lug and wires on the right side of...
Hey Stephan, yea, that's very near where we party every year, mid-May. There are lots of great routes to ride, try this one: From Bretton Woods,...
In 1998, I was cornerworking at Loudon when Miguel was racing the RVF750 (also the weekend he crashed hard). I have never heard such a...
Hi All, I've been lurking this thread for a bit and I haven't seen mention of W. Virginia - Anyone interested in meeting/riding in WV ? It's...
No PC here either, tho' I do have a Techlusion-in-waiting. The last dyno I did with the new FPR showed some changes in the O2 readings, but the...
Excellent, thanks. 10mm is close enough to work with. Scott
All; I'm looking to get a measurement of a 6Gen extended fork length - center axle to the fork cap flat surface. I've found it's easier to...
I installed an FPR on my 01 last winter - a major PIA to remove and install on the 5G. I had to loosen the 2 ? screws on the starter valve mount,...
Save your money and get an aftermarket STANDARD H4, not the underpowered Honda-proprietary-base H4. The stock bulb is 45/45W. 1. Buy a pair of...
I was just wondering if anyone has looked into swapping the VTEC fuel injectors into the 5th Gen FI assembly ? From the pics on Ron Ayers, the...
Another vote for the Conti RoadAttacks. I put them on in April, proceeded to ride to NH for the weekend in downpouring rain, did a 300+ mile...
Have any of you 6th Gen'rs removed or replaced a fork tube on your VFR? If so, would you happen to have it out and around and could measure the...
I did exactly what you're thinking, (43->45) and added two links (108->110) to the chain length when I did it. Totally worthwhile. It closed up...
Funny you should ask this. I just dyno'd my '01 last Thursday to get a baseline measurement before some modifications. It was done on a Factory...
I haven't worked with an Ohlins, but it has an excellent rep. I have replaced both front and rear springs with the Hyperpro springs ('01), and it...
Yes. See my entry in this forum entitled, "ATTN: All Single-Side VFR's". Short story: The axle nut is supposed to be torqued to...
Re: Bike died again..20 amp fuse pops for Fuel inj Sounds like there's a dead short somewhere, OR, both the battery AND the R/R are shot. Adding...
Try this: www.color-rite.com
Hi TM, A quick check of the Service Manual shows that the connector to the TPS is attached to the TB of the #3 cyl (right rear). However the...
Separate names with a comma.
