Funny this popped up. I'm finally off for a week and I'll be putting the Blueskysea in tomorrow.
That is an excellent suggestion.
Thanks, it's a complete fairing from Monster fairing, bike was 2008 silver. Not as flexible as Honda but good quality IMO and the color is YUM!...
Oh, I do have a grab handle on the filler ring for my daughter. There is a bit of a gap that it covers. Have a GIVI tanklock bag on the way to...
That's a tank cover. Have to install it when it's warm and even the a heatgun or hair dryer helps otherwise the tabs are easy the break.
Nice when a job goes well isn't it? Good on ya for tackling that one!
O2 eliminators may help. If it's running that rich the ecu is likely getting no signal at all. A PC5 is best but cost may be a factor.
Guess this falls under the "nevermind" category. Not practical.
Anyone drill and fit Zerk fittings on the dogbone? Looks simple enough, enough meat there. Sure would simplify PM work.
Wiremybike made those steering head power outlets. It's a USB for phones ect. Don't think you can get them anymore since everyone started using...
Heh, only as strong as the weakest "link"
Well, that answers the question I was about to post as to if the heim jointed link has any advantage over the dogbone. Wasn't looking to lower,...
They are Ebay, I believe Akashi. Thought I'd give them a try. No complaints thus far. Btw, decided I don't like the silver and black. Tires come...
In taking measurements is it safe to assume that when rider on sag is set correctly if the static sag is zero (topping out) the spting rate is too...
I did pair delete as I believe it was causing some AFR confusion with the PCV and autotune. Had the flapper disabled and the snorkel out till I...
Was looking at Harbor Freight, looks like it would fit the bill. Condor is nice but $ vs my useage. I figured getting off it is a chore but...
No... The garage type. Any one have recommendations? My storage unit is tight tight, I'd love to ride in and not struggle with center stand.
Go resisters that incorporate oe plugs. Mount them to metal to dissipate heat. No additional work for the RR to dump voltage as the resistors...
Do one at a time and lay the parts out as they come out. Not hard. I do highly recommend using an impact to remove the 6mm bottom bolt for the...
I'll letcha know when I get it :)
Separate names with a comma.
