Some states require you document the repairing of the bike and keep all receipts for parts. Then the bike has to be inspected. Check your...
Have heard of several bikes where the stock jets were drilled out. The jets have the stock sizes stamped on them but you really can't tell unless...
(84-86) carbs can be setup differently than 83's. Later models have: - front air tube with a single vent - rear air tube with 2 vents The front...
These are for the older V4's, but they might be worth a shot... Radiator_Cap - SabMagFAQ
When the bike is cold, the coolant needs to be between the Low and High mark in the reservoir bottle. Low coolant can cause all sorts of heating...
I believe it's to put tension on the screw so it doesn't unscrew due to vibration - sort of like a lockwasher for a nut.
Sometimes, you can do this: " oil" (put space before or after and use quotes) Or go to Google Advanced search and put in vfrworld.com as the...
You're going to have to pull the carbs again. Turn the rack over and make sure the throttle linkages move freely 100% throughout the range....
Sounds like the fans aren't getting power. With the two wires hooked up and the bike running, the fans should turn. Check the fuse. Cooling...
Rev's slow to drop is an indication of a bad carb sync. A different idle when you stop is another indication. When you chop the throttle, the...
Click on the "Operation" link for a step by step overview of the cooling system: <http://wiki.sabmagfaq.org/CoolingSystem>
Lube the pivot points and make sure the shifter is not hitting the stator cover. Also check out the "Won't Shift" section of...
Google gear undercutting. Dave Dodge www.drp123.com does them.
Get the gears undercut and you won't strip gears again.
It means to crack the banjo bolt while engaging the clutch lever - just as you do with the bleeder valve. Air gets trapped in the banjo bolt/MC...
I've got the entire brake system from top to bottom from my '85 VF700F. Works great too! e-mail me at mmsv45 "at" yahoo.com
Burp the banjo bolt on the M/C.
I second the battery. Have it load tested.
I've always theorized that the valve stem is lighter than the material removed from the rim for the valve stem "hole". Using my theory, the...
A good rule of thumb is that all the "lower" tubes are fuel tubes. All the "upper" tubes are air tubes. Between the rear carbs, the upper air...
Separate names with a comma.
