you can use the F2 or F3 caliper bracket for the rear...they are the same..you are using the F2/F3 caliper INSTEAD of the VFR caliper. Look at...
Ok i'm still at it. and still havent gotten her started yet. FINALLY started to focus on engine, checking for spark and found that the pulse...
you might be able to find cbf2 forks at a site like cbrforum.com, they are always parting out thier cbrs. there was a write on the other vfr site...
okay guys i figured it out...thanks for the help...woohoo.
This is from a 94-97 vfr but i circled the part i'm confused about. i need to know where it goes. [ATTACH]
no this connector is not for a screw...its looks like you push something into it. like a switch..i assume its the neutral switch.
Okay i was looking over my crankshaft pulse generator on the 87 700. i gotta question on a connection. i have the 6 pin coupler. and then i have a...
Okay thank you so much.
Does anyone have a working ulse generator for a 87 vfr700f2 or direct me on where i can get one. i am getting a really weak spark on all 4 plugs....
I hate i am poor cause i would sure be en route to you to pick it all up...
Not me personally, but there is some one over at the OTHER vfr site that is "cleaning out his garage", has a bunch of vfr700f2 parts. In case...
NICE!!! thanks for the ideas...yours turned out great...
Hey Electricrider, i have a motion industries by my house, i can pick them up for you and send them and the float needles to you. i have a parts...
oakley_burns...did you decide against the cbr600f2 swap...and where did you put yout FUEL PUMP!!! i got everything else pretty much in a...
i would suggest following toecutters carb cleaning tutorial. makes things a lot easier. and really depending on how bad the carbs are might not...
Thanks Squirrelman.
Okay back at it again...so i got carbs cleaned and no more leaks. WOOHOO!! now i was looking thru service manual and my carbs. looks like i mighta...
pretty much the same as oakley burns. except i used the vfr subframe versus the flat bar he used. i did use the thicker flat bar and an 18mm...
Yeah you could do that, you can just get a picture of the cbr600rr tail and cut and weld it to the original subframe to mimic the cbr600rr...
Separate names with a comma.
