I had wondered the same. I will add gravity feed to the to do list...
Copy that. Remember the small bore above the enrichment circuit fuel jet I asked you about? There is a plug in the bowl wall across from it per...
would a bad fuel relay be an issue in this mix? *hmm...nix that idea.
My main girl..a thing? Totally butt hurt :wink: Fuel pump is from a 96 VFR750. Same 900cc flow, correct? (please be the problem)
Hey Tinkerin...all my inlet needle seats have crushwashers installed. Been there since I have owned the bike. Is this absolutely necessary? I...
I have pilot jets from a 96. They are marked 40S. They have one less cross hole drilled. Not in a hurry to fuss with jetting. Wise to mess with...
40 slow jet Looks correct...[ATTACH]
Yes used the clear tube method. Yes. Inlet needles are new. *variable* inlet needles are for a VT600. And having talked to honda peeps at...
Stock 40 idle jet and 130 main. I am not sure the idle air mixture screws are not damaged. In my research the very tips of these are not pointed...
...and she wont start with enrichment on with any of the above combos
washer and o-ring are indeed present. In previous posts I mentioned the o-ring might be suspect..perhaps flattened etc. Will replace. They are not...
Understood. However bike will not idle at any position of mix screws. 1.5 turns out or closed, bike will not idle without using throttle stop...
Enrichment circuit is closed.
kennybobby has been an absolute incredible generous help with my issue. The problem has improved greatly but still not fully dialed. MPG on full...
kennybobby re: Idle [ATTACH][ATTACH]
rustedroot: hmm. interesting. good point. I have new boots. made sure to lightly lube them and make sure they are seated. Dont have new gaskets....
Yes thanks I didnt consider the break in period not being accurate. And big thanks for plug chop. Very good to know. I will keep updating...
And if idle jets are good?(didnt look drilled to me). would new mix screw o rings help? And what do over tightened mix screws look like...
starting with idle at 1k, I backed out the mix screws 2 turns. idle increased from 1k to about 2k. when i turned them clockwise to closed, idle...
Nice. I will adjust the butterflys now. Float valves have smidge of a wear ring, very little. They are clean...anal about that. I thought closing...
Separate names with a comma.
