Front brakes feel good again so I think that's that. I did the idle drop and the low end pull is back as well.
And the brakes feel spongy again today... Edit: I take it back... temporarily. I remembered that late last night, before I rode today, I needed...
[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH]
Hey guys, after looking again, I think I need a new mounting bracket all together. The metal piece that holds the latch in place has broken off...
Woody, you are the Man. The front brakes work great now. I assume this method is the reason why they put bleeder valves near the master cylinders...
I had a chance to test the bike again while riding and the 2k-3k jump was barely noticable. Another thing I noticed though was at low rpm...
I'll work on the idle drop this weekend. The rev jump happens while riding too. Its so obvious that its unsafe to ride the bike. There's...
I didnt even try it wide open, just rolling on quickly. It just didn't seem to pull as hard and wasnt accellerating as fast... Is there more than...
Ok. I think I understand. So before you posted that, I actually went back out there and tried again and I feel like I got them synched. Seeing...
Okay, so I turned the linkage screws a half turn, starting at the front, then the rears, then the bike died. This is where I got up to roughly. I...
Awesome. Thanks so much. Now, what exactly did I screw up by adjusting the other screw in my picture?
Mine does come with tiny little white valves, that are meant to control that... I forgot to put them in. Is there a picture in the FSM that...
I haven't started on the turning issue, but I will after I take care of the brake and carb synch. I didn't bleed them in a particular order. I...
[ATTACH] Like those? I dont see springs from my angle. And there's four of these... Also, what about the brake pad spring? Did anyone know what...
I see four different flathead screws. Am I messing with the wrong ones? I have a synch kit that I'm using. I'm not doing attempting it by ear.
Cleaned up the front brakes and reinstalled the pads. By the way, on the brake pad spring, there's two little pieces of metal that are sticking up...
Took the front wheel off (I dont know why FSM says to only remove right brake caliper as some piece of the left got in the way of removing the...
As far as the chain goes, I dont need to replace the sprocket, correct? Only if its worn? And should I count the teeth of the sprocket or...
Can you make a recommendation for a replacement chain? The rear sprocket looks good, but I'm not sure about the front one... I also dont...
Just a quick update since I just bought my front stand: The front wheel doesnt spin freely nor do the handle bars while the front is raised. The...
Separate names with a comma.
