I just put the Samco hoses on my bike a couple of weeks ago. They seem like good hoses. Don't forget you have to buy new clamps if you go with...
Having just bought an ebay kit, I can tell you that the quality seemed okay but some of the parts did not fit right. Fortunately all I needed was...
I used turpentine on mine.
I bought a VFRness and a Rick's mosfet R/R from Wiremybike.com.
I used a homemade sync tool for a while but I finally just bought a cheap dial type tool. You can get them for $40 or so.
Seems like it would have trouble telling the difference between a loose chain and a worn chain? Also, seems to kind of assume that chain slack is...
Should be a label under the padding near the straps. The one on the left I think is an RF1000 but not sure.
Just an update on this. Did the job yesterday. The pilot screws did not appear to be correct. Maybe they would work but the shape was a bit...
In the garage I have a pitbull for the rear and a cheap ebay stand for the front that lifts from the triple. In the trailer, I have a Harbor...
I bought it 3 years ago and it has never really sat. From the looks of the deposits in the gasket areas it's been leaking for a while, maybe even...
https://www.ebay.com/itm/194205049959 I bought one of these sets. I haven't finished the job yet but all the parts appear to be correct. I am...
I've had some ticking while cold since I adjust valves a while back. Some of the valves were a little bit tight. I have checked and double...
I like the Cometic also. Nice thing about them is they are re-useable (at least the ones I have used).
Have you ever replaced the sprockets?
I've used Caswell a couple of times and it works well. I've heard POR-15 is about equal but I have no first-hand knowledge.
I had one go about 12 years I think but not even close since. 5-6 years is about it now. I don't think they are as good as they used to be.
I would double and triple check around the garage. If the cam came out that forcefully, I think the bolt would have gotten launched.
I wish I had heard this tip before I did the job. After installing what I calculated were the correct size shims, I had a couple that were off...
I have a utility trailer with a wheel chock. Useful for things other than hauling motorcycles and it has a ramp-type tail gate.
having only done it once myself, I won't comment on the procedure but I will say that the easiest way to deal with the shims is to buy an...
Separate names with a comma.
