Weld it shut and ride the snot out of it Sent from my SM-S911U using Tapatalk
I like this idea Sent from my SM-S911U using Tapatalk
Ouch Honda wants $24 for that plug wrench. There's an entire toolkit for a cb900 or something that has the right PN plug wrench for like $27 but...
Length is important with this one [emoji23] Sent from my SM-S911U using Tapatalk
I'm assuming the stator is good since the regulator can hold it at 14.xx volts. If it were bad would the voltage not be lower? And if one...
I see the PN but none on ebay There must be a similar Honda factory tool that works Sent from my SM-S911U using Tapatalk
Yeah no I don't have the proper plug wrench. Whatever the PO had in there Trust. If I could find the right Honda tool, I would have it...
[MEDIA] Runs. Charging system good. 14.25 at idle. High beams and winkers still 14.2 Don't have the throttle cables hooked up, they are a...
I need to get the proper plug removal tool. Looks like NGKs in there.. so probably 18mm? Sent from my SM-S911U using Tapatalk
Well, it's totally the RH control pod that was causing the spark issue. I cleaned the contacts and the button, worked the kill switch a bit,...
Appreciate the help Cap [emoji481] Sent from my SM-S911U using Tapatalk
Nice! You think the 90-97 VFR should be bolt up and go with double checking the wires? Sent from my SM-S911U using Tapatalk
Ok so 1.xx voltage drop from coil to battery. No bueno And I dislike this shitty start button they have on the 500. Is there a good upgrade to...
Did some voltage checks. 10.8v on the black/white coil wire. 11.5v after disconnecting the coil bracket and reattaching.. ground issue? Kill...
I could get at least some backfire with this solenoid installed. Probably take this downtime to do the carbs in the ultrasonic and replace the...
Wires look ok. One of the power leads on the 4 wire connector got Real hot, it melted the red plastic housing. But the wire at the connector...
There is a slight groove in the end of the collar. Must go there? And looking at Partzilla the flange end is on the wheel side/inside. [emoji106]...
Bushing and collar arrived. Can't figure out the collar bushing orientation though. Is it shoulder outside or shoulder inside? And where does...
Engine not running it will only spit a few times unless it has constant 12v then it will pump continuously into an open container, as the manual...
It should still fire up with a gravity feed tank. Unless the cylinders are not getting fuel. Sent from my SM-S911U using Tapatalk
Separate names with a comma.
