I scraped a peg and broke the peg slider off on the oem dunlops that my 07 came with. As for safe lean angle, your toes would be sore before you...
Depends on many things. Short answer is yes, ive done it. But I had to work at it to do it since im 220lbs. A better question is why are you asking?
I have the cup wrench for removal but hand tight plus a little snugging with the meat-hooks has always worked fine, never a leak to be seen...
The expansion tank suffers from evaporation loss. This may not be the full story, but in 4 months I lost from the high line to low line and no...
:worthless: The pillion grab handle screws are black with allen (hex) heads. Every thing else seems to be shiney silver or matt silver. Welcome...
Rare but does happen, map sensor and iat sensor failures. Since these look like resistances to the ecu they may not throw a code. O2 sensors are...
That is a nice profile, that flat spot in the middle is probably the best you can do unless you reprogram the vtech cut in.
Look between the throttle bodies, on the front half is a silver cylinder with a rod sticking out. When cold this unit helps keep the engine idled...
Stupid as it sounds, your getting too much fuel. Use an o2 sensor and watch the afr and lean it out to maintain the curve. You will have a flat...
30 with an 07, had it since 08.
Sorry to hear about the carnage, glad you two are ok. While fighting the system, check into your states laws on cross walks. Last time I looked...
Sounds like the battery isnt taking a charge that well, since the charging system can only source 500w (36A @13.8v) and at least 15A is used to...
You get to do the, what undisclosed mods do I have game! Since the bike runs fin in low gears, skip tps sensor, look for hoses off etc. I have...
Ride on man, ride on! It will tell you when its time to adjust, just be ready to listen.
Charge your battery, 6 to 10a for 4hrs then 2a or less for 18hrs or so. Start with a fresh charged battery. Then start bike, attach volt meter and...
Sticky wax unit, sensor failing, sticky throttle assembly. Sounds like too much air is bypassing the throttle plates. Inspect, measure and...
You have a 6th gen, with the fork compressed add 18oz of oil and then pump the fork slowly to release the trapped air and to fill the valve body....
Needles, floats, crud/varnish on everything. I have a twinstar cm200t and learned the hard way about crap gas. Forced a major cleaning that...
recall, whole engine harness, main power harness. It all seems to be just under gauged for the loads. as for connectors, mostly r/r and stator,...
if it hasent settled completely look at the forks, nervous cornering, especially slow side street cornering is mostly old fork oil or not enough.
Separate names with a comma.
