yeah, I was lucky to swap a few to get all of the intakes set correctly. The intakes were pretty tight overall. I don't think this bike has seen...
Annnnd I run out of shims to change all of the exhaust valves clearances. Fack. 2.20mm and 2.25mm. We are still within spec at .008” on three...
Great job Biff!
And what fun are we up to today? [ATTACH]
Saved! Thanks again. Have you tried the OE equiv from them or only the genuine article?
I am sure I asked before. Reliable source for main jets? Summit won't send them to Kalifornia. wtf.
What did you do mister?! Let the beatings continue! That is a great color for those wheels. jelly.
Same rebuild tomorrow for me. Same mystery leak. Hahaha that bike looks Capt!
Oh and I am sure you peeps already knew this but I used some adhesive backed heat shrink to line the wire harness supports that age poorly. Also...
Yer all good. I can be hard to understand. Haha I think some 115s might be good middle ground.
Yes, you are 100%, but I can deal with 7k stumble over running lean. Tyga had put that info out for their exhaust system. They mentioned using a...
Bike runs like a top. I was going to leave these jets in and put in new plugs. Just a little unsure on jetting changes but I thought the plugs...
Good input. Thank you. Th rub is that it would be $50 shipping to UT. Another 50-100 to straighten and test. Hopefully clean up aesthetically. Or...
That looks like a nice impact driver. Mine is old school and works nearly every time. I did not work on the timing cover but that is a first. I...
Most likely. I am going to send out my radiator to Mylers in UT to be straightened. I was just looking at alternatives. Not much that I would trust.
Top Secret plans...shhh I look forward to the plans.
Anyone had any experience with GPI radiators?
I ran a hole shot on my SV650 race bike. It was ok. It died a horrible death at Sears Point Raceway. High side into T-10. On anything faster that...
There is something there for bidders. I have been fooled and now I stop bidding unless I am ready to pay for my mistakes.
Don't mess with inspector C.
Separate names with a comma.
