quite honestly, ive been riding my '89 vtr without a title for 30 years, and for years its the only bike i regularly use for transport, as i have...
hire a truck
rust in float bowl means youll likely need to drain, flush, and coat the fuel tank.
^^^^ its priced right, a fun bike, light, decent power, top speed about 105 mph, very flickable. love my vtr, and its my regular daily rider for...
good work. well-cleaned carbs if it will idle that low, but keep the idle speed about 1200. if it doesnt warm up, check that your thermostat is...
old seal on top of new seal protects and helps push it in place.
be careful not to use too much force, heat helps, tougher in a cold shop. loosen both clamps. front comes off ez after rears are out. [ATTACH]...
its a floating rotor, nice
dont have time for a reasoned responce, but i tend to disagree. rotor may circulate cooling air, and cover is scooping forward. been riding my...
its ez but be accurate measuring and cutting it. must be measured with the carb held at the exactly proper angle. [ATTACH]
test throttle response by riding the bike not just revving it in the garage. im starting to think the carbs may be properly cleaned but an...
by experiment ive developed an ez accurate synch method entirely new, simple tools, no equipment. checked w gauges OK method ive used for 3...
post a photo and tell about their service. gerald kadet, my father died flying a supply mission over the hump july 1945 just a week before the...
with all his bikes and years of experience, captain 80s would have the best tire info. recently put a new BT-45 rear on my '90 VTR 250 after...
settelin in for fewer riding days battery out on a charger, just hope its not like 2018 again...... [ATTACH]
not running
either way, easier w carbs off
let some carb cleaner spray drain down through all the progression holes.......repetedly. followed with compressed air.
look on the side opposite the big hole for 3 or 4 very small holes. line up the #1 reference carb throttle plate to just begin to expose the...
for a decent bench synch u should be lining up the throttle plate with the first progression hole starting w #1 carb. the big hole u circled isnt...
Separate names with a comma.
