Those old style RRs are rather Brutal on Stators. It accepts the voltage from the Stator Field, until it reaches design voltage, then, to keep...
Um,,.. "65 and over" and still picking up a "High Efficiency Travel Award".
I've repair'd 4 or 5 Ignition Boxes. The FET usually goes (2SD1071 or equiv ($1 each)). Did one a month ago. Also beef up some of the solder. New...
Fan installed in front of Upper Rad (the hotter one). [IMG] Runs all the time (power'd off Low Beam circuit).
2006 VFr800; [IMG] Get a Torque Wrench and Always use it.
Your harness is divided into 2 different wire gauges,,.. High Current & Low Current. When connectors are crimp'd ON at the factory, the Copper...
Heat from the engine rises and warms the gas tank. The expanding fumes push out the Gas Cap Breather. Less gas in tank, the worse it is. Go in...
https://mccawcompany.com/product-category/watchparts/crystals/mineral-glass/ Have done a bunch of replacements using this supplier.
Those Rubber Carb Venturi Tubes shrink with age and leak air in. I had to do the WinterGreen dunk to expand them back to fit into the seating groove.
Good goin! That pitted cylinder looks scary, will look better with a Hone. I went to town on the cooling holes, bigger is better, engine seems to...
I used to "fish" for Pickerel,,.. [IMG] I was inpatient in my youth.
Lookin Good, But, I would replace that Front Tire. Any Tread that channels water to the center (hydro-planning) is asking for trouble. You'll...
I did a full set of cams/followers a few years ago. [IMG] Was pricey, but was a more permanent fix. The cams don't have air pockets in'em, they...
Wheely Good; Why not Spin-Test a "bead'd" wheel? Run it up thru the gears while on the Center Stand, should be smooth up to 150kph. I've found...
Owning one of these Bikes is also a Total Loss of Money, but gotta spend it somehow,,..
Separate names with a comma.
