I rotated the carb funnel to match the others - not sure if the other three were in the correct position (or that it matters). On another note - I...
I have my bike apart to do some work and noticed something with the rubber 'ram tubes' clamped between the carbs and the carb base plate. They...
Hi All, I haven't posted in a while - hadn't done anything interesting on my Interceptor for quite some time (except ride it :cool:). I finally...
View from front of bike showing finished clutch lever end. Im considering grinding and finishing the end of the brake lever to match the shape.
Finished product showing installed mirror mounting hole cover, and button head hex drive mirror mounting bolt. The bolt heads were scuffed with...
View from the saddle. The visibility is awesome I can finally see around myself. Theres a teensy bit of vibration induced blur, but the mirrors...
Plastic panel fasteners that I had lying around the shop. I used them to cover the original mirror mounting holes. The shank is a perfect fit, but...
The throttle tube was modified to be about 0.050 shorter than bar end. Normally you want it a bit longer than bar end, but in this case you need...
I ran into a problem with clutch lever to mirror bracket clearance. It turns out that the lever mounting position is a bit different on each side....
Here are all of the parts involved (except throttle tube and mirror mounting hole plugs). Crude hex head bolts at top were replaced before final...
I used this project as an opportunity to clean up the tired looking handlebars. The handlebar on right is smoothed and finished with baked on...
The bar ends were drilled and tapped for M8-1.25 bolts. A machine shop friend did it to make sure it was straight. Cheapo bolts shipped with...
Throttle side grip, throttle tube, and homemade washers. The thin, hard plastic washers are used to reduce friction between soft grip and...
Separate names with a comma.
