And carbs were synched this evening. I did a quick run south of town, and she is much smoother with everything set correctly. I'm looking forward...
Well, the bike made the 200 mile round trip to my girl's house without incident. The Goldwing came out of the garage for the ride to work...
So she is on the road again. I popped her together with the complete setup from the new to me carbs, and she seems to be doing okay with no dead...
And where is the preferred place to get jets (in stock)? I looked at rocky mountain, and they show two (I think) different jets, and I don't have...
I'll plop it together tomorrow evening with the parts from the new carb. They are certainly from a kit as the lack of a K on the jets are what got...
Which is why I'm leaning towards the slides and jets from the new carbs. They are complete and matching from what I can tell. I'm just not real...
So carbs arrived from BluRoad (thanks for the fast shipping and fair price!), and I have them mostly cleaned. I did run into two minor things. One...
I'll go with your set. Email sent.
I had looked at both of those possibilities. I'm not ready for the $400, and I'd hate to go for fire damaged carbs without being able to see them...
Good to hear. So far it looks like it is going to be $200ish for a cleanable set. I'm holding out to hear what a few other places have to say, but...
Will I need to rejet (which should not be an issue as I have the originals) or will the 700 be a bolt on? Thanks for all your help. I was hoping...
For better or worse, it is done. Before I made an .080" hole all the way through, I noticed that my .040" drill bit did not fall through the other...
It occurred to me while I was digging through my drill bits for something a bit undersized to start the hole... I have those really sweet screws...
I contemplated that. I'd be mighty annoyed if that JB worked its way out and found its way inside the engine, but I suppose I could put some...
I wish someone would have told the last guy. I read Toe Cutter's thread and another thread where you were telling an MMI student not to do that...
Separate names with a comma.
