[ATTACH][ATTACH][ATTACH][ATTACH]Hi guys.. just parked a first gen vfr next to my 4th gen in the garage.. deal I could not pass up.. missing a left...
Sounds like the R/R ... I just installed a Mosfet from Roadstercycles.com..There is a test for the r/r from pin to pin and mine had burned out...
[ATTACH] this is the kit pre soldered and for 10 dollars more well worth it and again it is Roadstercycles.com
All you need for this is a soldering iron.. no tapping into the harness..there could be an issue with the harness itself so this is a direct route...
this was the kit i installed, he offer videos and even in person instruction if you are having issues...
I was having some issues with mine as well in the same area and replaced my R/R with a Mosfet from Roadstercycle.com, the guy builds the kit to...
I installed an Hrc Jet kit on my 1995 VFR..also the K&N, and with those i removed the baffle from my StayInTune Pipe and the snorkel from the...
yes, purchased from Amazon...returning for refund tomorrow do to the junk status:( big waste of time
Someone suggested running a jumper wire from the ground to the neg terminal and a hot fused to the pos terminal spliced right from the output of...
from the new one im getting nothing attached or not, the old one seems to have a short inside that is activated when it touches the frame..the new...
Hanging Regulator So i was at a loss for the charging issue with all checks good ,new reg and all, still no charge at the battery at all with...
I just remounted the old reg/rec back up and there was zero charge rate again...so i unmounted it and let it hang off the bike and it charges?...
Well i tested the Stator output ,good, the battery is new, i bought a replacement reg/rec and was not getting any charge to the battery and for...
Reg/Rec heat? After a few minutes of running to warm up should the reg/rec be very hot to touch if its brand new?
Separate names with a comma.
