Hey man, I put a motor from a 2001 vfr into my 1998 vfr and used my existing harness and wiring. Have had no probs, runs fine.
The only theory i have is that i replaced the bearings inside the housing (left side) with some from a bearing supplier, two of 6908rs 40x62x12...
Hey All, Has anyone got any thoughts on this? I've got the exact problem. When i removed the stub axle nut it was just nipped up, to stop the rear...
I’ll go ahead with it and let everybody know how I go. Cheers
Hi everyone, I’m new to the forum. Would like some advice. I’ve got a 98 model and looking at an engine swap with a 2001. As far as I can see...
Separate names with a comma.
