Thats what I did, used all 4. Try and use Honda ones from a Civic for example because the taper can vary between manufactures which doesnt make...
sensor for the fan is on the right side of the rad. sensor for the temp guage is on the thermostat housing. I have dozens of used hoses for VFR750...
RAL 9003 is whiter than white white. I have a powder coated wheel on the Bay UK
Its up on the right side near the fusebox just taped to the loom. You would need to remove the top fairing and then its pretty obvious
I have a lot of these covers and can send you one but i am in the UK I would need to check postage
Its happened after a lot of things, why do you assume there is a connnection? Yes its easy to do, you just need a clutch cover gasket .
because it has not had a 15amp fault yet, could be.
its fine, I have had twelve of the 4th gen and only one ever reached halfway up the gauge when the fan kicked in, most ran were yours is
pm me. I have all the parts you will need, reg/rec. plug with part of harness, alternator rotor . all used but good
Well Ipersonally I have had a fall off a paddock stand and seen two driveway tip ups this year so I believe it, its easy to tell anyway, there...
not usually but they would cause a weak mixture. As said in a prev. post, these bikes usually run rich if anything
If you mean the connectors on the bulbs, just pull off but can be tight, wiggle, wiggle, wiggle. remove rubber boot and headlight bulb is held in...
second that. 90 - 93 5.5 inch, 94 - 97 5 inch, 98 -------------------------------------------------------------------2015 5.5 inch the 5...
M6 but not a normal nut. The pillion grip bolts are bigger but "normal " bolts Then there is the special Frankenbolts
Take out the two large side bolts, then the two Frankenbolts and remove the seat and remove the pillion handles. then spring the front both sides...
Separate names with a comma.