ok, (air funnels) per parts list naming are dif. sizes. do the smaller ones go up front and the taller ones in the rear?
ok, I had to replace the fuel preasure reg. and I pulled everthing off but I didn't notice that the velocity stack are dif. sizes. Do the short...
does anyone know how to test the abs sensors, I get electrical continuity through the harnes and the gap in the front seems a little off. Is there...
i think it in the new harness!!
ok, that was not the prob. ya you can't put the spacers on wrong.. going to keep looking the dealership a waste of time..
yes, but if the sending unit is not close enough it doesnt see any movement. fixing right now plus im putting on new brakes
ok, the dealer said the reason the abs light will not go off is because when I put the tire back on I got the spacers backwards and the gap is to...
ok, Im taking the bike in next week for them to look at it. I tried to do the code retrieval procedure and nothing worked. I pulled both fuses...
oh, they had to check somthing to do with the rear brakes master .. it was a recall issue aswell..
not blinking just stays on.. it was working fine before I had the harness replaced.. Ill try and clean the sensors aswell.
Ok, just got bike back from dealer, had to have the wiring harness recall done. as I picked it up I noticed and the shop said that the abs light...
not plugged up. I have to take to dealer anyway, Ill let them check it out.. this is my number 2 bike so if it down for a few it wont hurt to much..
I have to take it to the dealer tuesday for the electrical recall.. it was never done. could it just be that the electrical finally failed today...
Separate names with a comma.
