The fairings were from the bike. They weren't on when I got it back. They needed to have the paint touched up and clear coated. They are original...
Thanks, I stripped it down to the frame last winter and cleaned, restored or replaced each part. Sent from my iPad using Tapatalk
Installed the covers on the bike today. The side covers were pretty straightforward, kind of a pain removing 30 year old gaskets with a razor...
I should add that if there is anyone in Toronto area that needs this done... contact Len at Edge Coatings in Newmarket. Sent from my iPad using...
Lol. Thanks. Normally but these are spare covers from eBay Sent from my iPad using Tapatalk
[IMG] Finally found a match for the 1986 vfr750 engine covers. Picked them up from the powdercoater this week. PTB-6794 "Bronze Texture,"...
Thanks, it's been a labor of love for sure. Sent from my iPad using Tapatalk
Finished the rebuild this spring. It's better than I remember back in 86. What a difference from the start of this thread.[IMG] Sent from my...
Got the carbs back the other week. All cleaned and setup and balanced. This is the econo cleaning. Damn they look new. [IMG][IMG][IMG] It's...
Yeah, but I have less than 1/4 inch room from the brake stay. I'll double check in the morning to make sure I'm not mistaken. Sent from my iPad...
According to partzilla the gas cap for the 86 is still available Sent from my iPad using Tapatalk
I have a 160 k comp on the back of my 86. It's been on there since 2003... I'd be interested in hearing about the life of these. Mine has low...
I'm getting mine done. Powder coated Rockwell bronze from prismatic. Perfect match and same finish... wrinkled. Sent from my iPad using Tapatalk
They aren't all bike ugly machines that cost over $25,000. Here's one less then a new VFR. [IMG] [IMG] A lot of them are being turned into cafe...
Separate names with a comma.
