Yes, that was the problem and I did run wire through the low speed idle jets, and just like you were saying I could see light through them but...
BZ/Masonv45, Ok this weekend went well I checked the charging system and that was good. Then I moved on to the tank vents, the smaller one was...
No I see what you mean, the pilot screws have stoppers on the end of the screw, and you can only turn them so far before they hit the float bowl,...
By the way it's a 93, I hit 2 on accident. Nate
Masonv45, Sounds good, I will be heading for the garage in a few. Thanks for all of the advice, I will keep you updated on my VFR crisis! Nate
Masonv45, Now with that berrymans, does everything that is rubber or neoprene have to be reomved first? I seen the pilot screw settings are very...
Masonv45, I did try spraying around the boots with it idling, nothing changed. Thanks, Nate
BZ, Masonv45, When I cleaned the carbs I used spray carb cleaner through every jet and passage then used compressed air through the passages. As...
BZ, Well im going to work on this thing tonight, I'm going to start with the charging system, then remove the tank and check those vacuum lines....
BZ, The bike has a little over 30,000 miles on it, As far as the previous owner go's, he said it ran great when he parked it. He bought it with...
Okay, yes I have adjusted the idle cable, as soon as I start to turn it up or down it will stall. It's set right now where it will just idle and...
Waldrm, I was thinking something still might be gummed up in those carbs. Do you have a link or a diagram for the location of the low speed...
Hi, yes I did adjust the throttle cable at the carbs and I made sure that all the slides are in sync, so none are higher or lower than the...
http://vfrworld.com/forums/introductions/9893-1993-honda-vfr-750-a.html
Separate names with a comma.
