No it did not
You can get a 3 connector turn signal "Relay" at most any auto parts store. A "Flasher" is the thermal type. The guy behind the parts counter...
http://www.mrcycles.com/oemparts/a/hon/506c3621f870023420a32194/turn-signal #15 - near the rectifier
Watching "How It's Made" inspired me to use play dough to cast a replacement side cover pin. It's kind of a sand cast idea - except using play...
Do you have a better part #? I searched for that number on the napa website and came up with nothing....
If you do take the linkages off, separate and soak them, you only have to do it once.
You need cartridge emulators and you need to replaced the head bearings with tapered. Then torgue the adjustment nut so that the front "barely"...
On the emulsion tubes, the tubes with the holes farther away from the main jet install in the rear carbs.
Hey hoobatech, I think I might have one. I'll have to look in my garage this weekend. Shoot me an e-mail: mmsv45 AT yahoo.com
Sensor for a voltage gauge ??? There were several "models" of the VF1000F. Maybe one of them has it?
The tach runs from the yellow wire from the coil connections. Good way to test which coil is going out...
Check the underside of the fuel cap. Does it have a black plastic thingy on it? The "thingy" is a vent. It can get clogged. Shoot WD down the...
I've used Mequiar's "PlastX" with good results!
I have a 160/60 Avon Azaro on the rear of my bike, but the narrow rim causes it to round out so much that I don't get any more surface area than...
Separate names with a comma.
