Okay so I may have messed up big time... Tonight, as I was just butting everything back up I checked the service manual to see the torque...
Okay first off— I want to thank you all for helping me through this trouble shooting. Im learning a lot, as this is my first “restore”. Okay so I...
[ATTACH] [ATTACH] [ATTACH] So I took it off just now, and cleaned up the mating surface the best I could (bolt holes, and such not included) just...
Okay so I just took it off, dried off the gasket, used a stone the best I could, put hondabond on (only where the crankcase mating surfaces are)...
Might be kind of a dumb question... but like a literal stone? Or like a pocket stone for sharpening a knife?
Yes, I do star pattern every time. In the 99 model of the vfr, all bolts are the same length. However I don’t do the recommended 12 or so nm of...
hello all, I have a 1999 vfr 800 fixer-upper. Sooooo I’ve just finished a new clutch instal and it all works and everything, BUT when I instal...
I’ve bought two gaskets so far and every gasket maker under the sun it seems like. From all the advice I’ve been given, about gaskets, is to use...
Okay everyone I’ve fixed it, just In case you were wondering. I got my service manual in the mail, and read the intsillation procedures for the...
Yeah just bought a used one for $10 online. Thanks, but no thanks. I can get atleast a nickel for it elsewhere.
[ATTACH] Here’s where the gear seemed to fit. I know this isint quite my model, but it looks extremely similar. I’ll post an actual picture when I...
The gear that popped out is the one on the right of this picture. I’ll look around my garage floor....
Yeah, I meant stator magneto thing. As in the small wired electronic bit that has a magnet on it, I can only assume is used to recharge the...
Separate names with a comma.