I have the oem cases and from reflector to reflector is 37 inches. I always forget they are there and I have hit everything with them. Both of my...
A nicely trimmed piece of electrical tape seems to be working just fine. :)
I assume my cluster was replaced because the bike does not have ABS but the light is there and on at all times. A picture wouldn't really work...
Excellent tip on using air to install them. I already had foam grip covers but have been unable to put them back on since installing my oxford...
The lust lowering kit is just the triangle plates, not the link. I'll have to try to find the stock link on eBay or something.
The best comparison I can make to mine is a mustang with borla exhaust. That's what mine reminds me of. I don't have the full gut though, I just...
Ok, so rode it with the rear low and the front stock. Steering felt heavy and when turning, the bars would want to tuck in like the bike wanted to...
I don't have a center stand so can't do much there. From center to center of the link is nearly 5 inches. From the top of the tire to the exhaust...
Thank you, it will be greatly appreciated.
So i'm back to square 1 with no clue as to how much the rear is lowered. Could you measure yours from center to center?
Can you tell by the orientation of my triangle if it is on correct? Or if you see the same number of threads on the link?
Tires are shot, new ones are ordered. Maybe I should just put it back where it was until they get fitted.
As soon as I can figure out where the rear is supposed to be ill know if I can deal with it or if I need to lower it some. Once again, all...
I liked the height it was at, but the front end felt very nervous. If you barely gave the bars input it took off in whatever direction you were...
I'll measure it tomorrow, thanks. If you or anyone else gets a chance and can take any other measurements it would be greatly appreciated. Thanks...
Separate names with a comma.
