Thank you so much, Grum, for hangin' in there with me. The string example -- that didn't seem 100% legit until you said that the wax unit is...
That attachment of the ECT closeup was very helpful; thank you so much. (Curiously, instead of G/Bu i have G, and instead of G/O i have G/Y. I...
Finally bought an ECT sensor, installed it, put it all together and fired it up -- and the coolant temp immediately read about 232F, quickly...
Yes, that whole airbox is off nearly all the time i'm testing, and i've come to closely monitoring the warm idle plate position in relation to the...
Thank you, Grum. That last data point helped me get as close as I'm able to get to all systems go. My fast idle now hits 122F at 1200 rpm. The...
raYzerman, yeah, my manual says the same thing -- "count the turns". It wd be SO helpful right now if they gave a recommended range (you know,...
raYzerman, you wrote "adjust it to the range of vacuum the good book says". Exactly how would you do that? Are you able to change the level of...
Terry, that one's pretty different from mine, having all SVs in one place, off to the side. Mine are each next to their own intake port. That did...
I did a little research on the possible altitude effect. One website i found gave a chart showing the change of air psi at various altitudes. Sea...
I finally opened the SVs enough to return the Wax Unit back to its original setting. Then, the challenge was to get them to the sweet spot where...
Grum, that did not directly help, i think because mercury levels are going to seek whatever they seek. Yours show 24cm, but i could never get mine...
I'm starting to piece that together after reading some of your replies to another post from a few years ago. Glad it's you who's responding....
Did you get an answer to this? I have the same bike and fast idle does not work now. I can't trace it to any particular event.
Separate names with a comma.
