My key won't open the fuel tank on my 5th gen. Nothing new in the world about a stuck lock cylinder. Any tips on getting it unstuck? I'm...
Mohawk, Wow, that's a high tail! I bet the bike feels super responsive at that angle. At 5'7" (170cm) tall and 150lb, though, I would have...
If you have any trouble finding the 3M film, you could also consider clear plasti dip. Put it on as thickly as you like. You would probably want...
Absolutely. No problem there. When you have run out of preload adjustment, add shims. Or, if you keep running into max extension on the shock,...
I'm far from wanting to pick any fights here, so I hope there isn't any implied tone of voice problem in this at all. Grey, I'm going to end up...
I really don't like to see people threading things into aluminum without a torque wrench. The tendancy is already for people to overtorque stuff,...
Having just done the front wheel today, I can tell you the torque specs on the caliper, pinch bolts, and axle bolt are all far less than you might...
All done. I left the fender on and took the right caliper off. Plenty of clearance from the other caliper. I was doing this to change a brake...
OK, I'll step them up a little. I tend to do a lot of poking around in traffic, so I'm generally shifting at 4 and hardly using any power. I...
OK, so exactly the same as preload adjustment in that it raises the bike's rear end, but limits compression travel and adds extension travel....
Wow. I ride between 3k-4k all the time in my '99 VFR800. Should I really be cruising around town a 5-6k?
Route the whole assembly straight to the dumpster. Ha!
Thank you!
Quick question for you: 1999 VFR800 Do I have to remove the fender and brake caliper/s to remove the front wheel? It looks like there...
Separate names with a comma.
