I got one from a member here. Mods can delete.
PM sent.
Hey Everyone, I'm searching for a fuse cover for my VF500F. PN 38210-MF2-000, fits all years 84-86. I'm located in California and willing to pay...
I'm looking for the fuse box cover that goes on the top bridge, do you still have it?
On my '86 the PO used two 90* elbows. Works great.
The carbs were cleaned out prior to adjusting the valves. They are spotless inside but I need to double check what I have the pilot screws set at...
This bike isn't done yet! My compression tester, as it turns out, is missing an O-ring. I readjusted all the valves and checked compression with a...
I wish I had taken a compression reading before tearing into it. It was running, albeit poorly, before attempting to adjust the valves. I am going...
Sorry it took so long to get back to this. I did a compression test on the front 2 cylinders and only got 30PSI in each cold. I did the test with...
I'm not sure if you are familiar with the California carbs/evap set up on the '86, but let me try to explain what I did to get rid of those parts....
Hey everyone, I've been working on my VF500F but I've run into a bit of a snag. First a little back story, I picked up this machine about 3 months...
It doesn't melt it, it dissolves it - it is a solvent after all. Acetone, more commonly called finger nail polish remover, will do the same to ABS...
Is it really any worse than acetone, toluene or other harsh chemicals?
Separate names with a comma.
