Recent Content by gdl

  1. gdl
    Post

    VFR VTEC 2008 - Throttle issue! (another one)

    I'm going to second the tightening of the throttle cables. I did the PCIII and O2 resistors on mine and it vastly improved everything except for...
    Post by: gdl, May 28, 2009 in forum: Mechanics Garage
  2. gdl
    Post

    PC III vs. Water

    For some reason I can't get the powercommander.com site to open on my computer but I found a faq page on the dynojet uk site that will answer your...
    Post by: gdl, May 5, 2009 in forum: Mechanics Garage
  3. gdl
    Post

    Front wheel install

    I hadn't actually experimented with it but I suspect that if you swapped the spacers around then the brake rotors wouldn't line up correctly with...
    Post by: gdl, Apr 28, 2009 in forum: Mechanics Garage
  4. gdl
    Post

    Exhaust sound clips

    That's actually not bad, I like that minimalistic style. How did you go about turning the gutted cat into a muffler?
    Post by: gdl, Apr 23, 2009 in forum: Mechanics Garage
  5. gdl
    Post

    Front wheel install

    I recently took my front wheel off to get a new tire installed and when I went to reinstall I noticed the same thing you're seeing. I assumed it...
    Post by: gdl, Apr 22, 2009 in forum: Mechanics Garage
  6. gdl
    Post

    Gutted exhaust for sale

    I can't speak from actual experience but I can tell you what I recently had in mind for a maximum when I was looking for one. That would be $200....
    Post by: gdl, Apr 14, 2009 in forum: General VFR Discussions
  7. gdl
    Post

    Newbie w/2 Questions

    If you want a factory tool kit you can get them from HondaParts-Direct.com. This page Honda Motorcycle Parts – motocross, cruiser, touring,...
    Post by: gdl, Apr 14, 2009 in forum: General VFR Discussions
  8. gdl
    Post

    Problem starting, odd exhaust, and cutting out- HELP!

    That's what makes me think there's a restriction there, the right-hand muffler is the one with the direct shot from the mid-pipe. The left-hand...
    Post by: gdl, Apr 7, 2009 in forum: Mechanics Garage
  9. gdl
    Post

    Problem starting, odd exhaust, and cutting out- HELP!

    Hi, I'm fairly new to the board so I'm definitely not an expert but since no one else has replied I thought I'd throw a few things out. On the...
    Post by: gdl, Apr 7, 2009 in forum: Mechanics Garage
  10. gdl
    Post

    6th gen saddlebags

    Installation is relatively simple if you have at least minimal mechanical aptitude. There's a separate frame piece for each side, with mounting...
    Post by: gdl, Apr 1, 2009 in forum: 6th Generation 2002-2013
  11. gdl
    Post

    tires and abs

    OK, I went and found an online manual for a 2007 and in the ABS section it does say to follow the tire recommendations listed later in the book....
    Post by: gdl, Mar 21, 2009 in forum: Mechanics Garage
  12. gdl
    Post

    tires and abs

    I'm not home right now so I can't check my manual to be sure but I seem to recall the warning pertaining to the tire sizes as opposed to the...
    Post by: gdl, Mar 21, 2009 in forum: Mechanics Garage
  13. gdl
    Post

    new owner

    Northernrider, I just sent you a pm with a link.
    Post by: gdl, Mar 12, 2009 in forum: General VFR Discussions
  14. gdl
    Post

    Taking off the tires

    There are actually spacers on both sides of the front axle, at least there was on mine that I just did. One is longer than the other so make sure...
    Post by: gdl, Mar 11, 2009 in forum: Mechanics Garage
  15. gdl
    Post

    Up Load Map To Pc Iii Usb

    I just installed mine. If the PCIII is off the bike, it has to have external power in order for it to communicate with the computer. Mine...
    Post by: gdl, Mar 9, 2009 in forum: Mechanics Garage