I am running power directly to the fan motor. I think that my toggle may have contacted on the frame near the bars when the bike was running...
I know, I know. I'm quite embarassed about my lack of electrical knowledge, I guess I never really "got" it. What I don't understand is why I am...
Please excuse my ignorance, but what is a relay? And a dead short?
Anyone in Weld out there? I'm an experienced mechanic in Greeley and am always happy to lend a hand if someone needs help working on their...
I would also be interested in any info anyone can provide. I have an '86 500 that the cluth hydraulics don't seem to do anything at all. I have...
I just had a couple of wires spontaneously combust! Wiring/Electrical work is not my strong point, so maybe someone can lend me some advice. When...
Do you have the correct battery and have you checked to see if it is fully charged? If the battery is dying when the bike is running you might...
Ok, so I got the Interceptor running good with no pump. My problems were due to carb issues, and now that I have those ironed out, it runs fine...
I had dreaded pulling the carbs for some time because of the intricacy of the setup, but it actually wasn't too bad. I took off the upper choke...
I had flush-mounts on my '86 500. I think you can still get them at JC Whitney on the cheap if having the name-brand units isn't important to you.
So I popped my carbs off yesterday, and found my problems(I hope all of them!). The carb boot on #2(my problem cylinder) was split wide open and...
If you remove the controls and wrap some electrical tape around the bars where they mount, that will give the controls something to "bite" onto....
So I have my bike running pretty good, but have run into a little confusion. Cylinders 1, 3, and 4 all run very well and at the proper temp with...
Separate names with a comma.
