I’ve got another question. [ATTACH] The bolt on the right is the original one, which was stuck and I had to broke the hexagonal inner shape. The...
The manual is not that clear, it calls both “seat spacer” and in the drawings they have no differences. anyway it makes sense the way you said...
[ATTACH] Hi everybody, I’m doing a rebuild of the front forks, but I’m not sure about the order of the spacer seats. In the picture attached,...
I sprayed on the bottom of the manifold and doesn't suck air from that, no RPMs increased so I guess all fine there if I get it right, you mean...
How do they look?
do you guys push them with so much force, the ones in front? This is what I do, but maybe they just need to be seated without forcing? Because for...
Yes, and it still. If you imagine splitting the intake mainfold in two parts, the part facing the front is the one who leaks. The part (of...
Yes, I changed them a few months ago. Do you think the pilot screw could be related? I noticed that the rpms increase only if I spray starter on...
They were not any extra plumbing or stuff around there, just checked. I installed the front ones in the carburetor, tightened them good before...
Yes, I always spray on that first and nothing happens, unfortunately The fact is that if I spray around the bowl area it increases too… What...
the gaskets of the bowls, maybe they don't seal good, I don't know what could be the problem now
removed the limiting collars and still increasing RPMs if I spray starter. So I swapped the insulator and still on #2 carb the RPMs increases......
this is absolutely something that could do the trick! Gonna remove them right now and try, be right back
Do you find useful to seal with black joint silicone all around the insulator where is getting the carb?
Separate names with a comma.
