I (very cautiously) used ratchet straps to assist in the carb installation a few months back. Prior to doing this, I tried heat, lubricants, and...
Got it resolved a few days back, as stated. Thanks everyone. The issue WAS the clutch plate. For those reading this forum at a later date with the...
Thanks all. It was the clutch plate stuck. It is freed up now. What I did: 1) have it in neutral 2) roll forward 3) pull clutch and shift The...
To anyone who has tried the "push til you drop" method, did it seem to pulsate as you were pushing forward? Apparently my clutch plates are stuck...
Thanks for your help guys. I will try rocking it again this afternoon after work to free up the plates. If that doesn't do the trick, I'll drain...
Valid point!
Clutch system has recently been bled. Line is clear of bubbles. I checked it again this evening and same result, no bubbles of any kind. Do you...
I tried this and it seems to lightly "pop", loosen up and then get tight again. I don't want to keep doing this if it is wearing something out....
I decided to post the "help" portion of my intro on another thread. So... Hi! Pic to come soon.
Thank you both. I will try both ideas. However, I have a feeling it may not be the master cylinder or slave cylinder, as I bled the clutch system...
Recently bought an '86 VFR700 that sat for years. Trying to get it back on the road. Bike won't shift into gear. She'll start in neutral and run...
I recently acquired a 1986 VFR700 and man am I excited to actually get it on the road. I'm not one to go out and pay someone else several hundred...
Separate names with a comma.
