Both of my 5th gens had/have this noise. With experimentation, I could get it to happen in lower gears too. The only thing that I coul put it down...
I've had Staintune and Delkevic on the 5th gens. Delki wins on bang for buck, hands down! Delki isn't as solid as Staintune, but TBH, my delki...
How are you going with this problem? It could be the sensor wiring connector, or the connector (for all the sensors) on the wiring loom. Possibly...
Guys, you need to read it again... He said that he didn't have the FI fault light. There are codes that can be set without getting the FI fault...
If you short out the diagnostic connector (two wires going into an unconnected plug on the LHS of the rear sub-frame), you can count the long and...
5G and 6G ECU plugs are different, aren't they? Plus the wire routing is different for a few essentials like the injectors and cam/crank angle...
bikebandit.com US$68.56 (postage extra). Buy new, not used. A used one might fail the day after you put it onto the bike....
Are they doing a 5G loom?
My '00 with a 13" stainless tri-oval by Delkevic: [ATTACH]
If you remove the PAIR valveplumbing and install block-off plates and a bung on the air box, it will become an easier job.
Unless it leans it out enough to stop it from firing properly. It would make less of a difference at high RPM, where there's a lot more air going...
I dunno about anyone else, but I don't have to go and look at bikes to need a drool bucket... I'm sitting here looking at the scorching hot chick...
Mick Doohan without a doubt!
Very nice! :)
I don't have a mountain bike, but I am a mountain man: I like mountin' women! ;)
Separate names with a comma.