Thank You! The ground to coil #4 was cut in half.
Well, shoot. #4 (front right cylinder) is not firing at all. I jumped the fuel pump and it primed the float bowls and it fired right up. I let it...
Well i decided to open up the drain screw on the left front carb and nothing but a dribble came out. Same with the rear left. Left the screws open...
Fuses are good. I may have fouled or flooded it not to mention it's cold today. Lower 50's. I'm going to let it set overnight and try again tomorrow.
I tipped my bike over in the garage. It ran perfect before that. I have been repairing the damaged plastics for the last couple of weeks. Thought...
Same here. Just got one and love it.
I was thinking of doing the bottom fairing piece that is already dull black on the 4th gen. Not sure if that stuff will hold up to the heat while...
I just put this on my '94. It still has the factory baffle in it and I must say it sounds great. It is smack in between a stock exhaust and the...
One thing to note about the carbs on the 4th gen; They are connected via metal shafts that run through the assembly. It is easy to remove the...
Buell has a clear tank, well, airbox cover actually, that i could see the single rubber v-stack inside of. Hmm, a honda v-four in a Buell XB...
8mm is correct. Once you have one set of bowls off the bottom screw is easy to get to with a phillips screwdriver. Make darn sure to return each...
I used to be a toolmaker. You have some talent! You have inspired me to learn to weld aluminum and make some too. Great job.
Piece of cake! Bike purrs now.
Separate names with a comma.
