Suck my dick hope you end up dying alone
All you had to do was just tell me to drill out the cap on the other side, it wouldn't have been that hard to say that I finally found a damn...
Bro you said asking question is encouraged did you not? The other side is blocked off right and this side has no where for a damn screw, I'm...
It's hard to see but that is where everyone says the mixture screw is supposed to be there is nothing there and the other side is blocked off
I don't have a damn manual
Okay where is the fuel mixture screws I cannot find it I swear I knew where it was but I guess not
I'm dumb as he'll lol I don't know why I wad mixing those up so bad give me one sec in those
Okay so the mixture scre when ever I bring that out 2 turns it just pours gas everywhere and also cleaned out the idle jets properly as well, I...
Still nothing I did that and now it won't stay going without the choke on I've retraced my steps through the whole thing and still can't find...
Yeah you go 4 2 3 1 for sync right basically I'm just using feeler guages and setting them all to the same one
Okay when you do a rough sync cause I can't do the vacuum sync you adjust carb 4 with the idle set screw am I not right on that one? I didn't see...
Okay so every time I adjust the idle screw down it dies after 2500 rpms should I increase the gas or decrease it, I don't know if that makes sense...
Gotcha I'll bring it down
Okay so after long ass hours we got it running I just used feeler guages and adjusted them all to the same one and it runs with out need any...
Yes I have an air compressor, I promise it is gravity fed I don't mean to sound like an asshole lol sorry but it is gravity fed it goes straight...
Separate names with a comma.
