I see your from Edmounds Wa, I used to live in Kingston, and take the ferry everyday on one of my many bikes at the time. I was poor then, and my...
Its finding the parts thats hard...I have some money saved for this project..but parts are not to be found. Because of the gear driven cams,...
Yes..indeed stuck in the 80's to prove it...my bikes: 1985 RZ350 1981 GPZ550 1981 GPZ1100 1986 VFR750 ZRX1100 << replica of a 80's bike Some 90's...
Check it out, really friggin nice. Where in the heck do these people get the HRC and AHC parts? Does ANYBODY on the forum have any of the...
As comparison, my brand new 1997 VFR750 dyno'd at the rear wheel with 90.1 hp and 49 lbs torque after having the idle jets drilled and dropped.
Yup your right on both bikes and planes. Airlines are begging for pilots and going out of business because of it. It's too f**cking expensive...
Well, I saw a video of Joey Dunlop Woop ass on a pair of factory FZR1000's on his "aging" RC45. Pulled them down the straights by a few mph;...
Crazy talk here...there is an Rc30 engine for sale on fleebay for ~6000.00 tempting to get and put into 2nd gen. Add some simple suspension,...
Holy sh** how'd find that? Thanks for the info. 577nitro
Not sure where to post so I'll start here. A while back I started down the road of getting more power out of my 86 VFR750. I did some research...
Mines off +5 mph . used to be you could adjust tension on the needle spring, tighten to slow the MPH down, etc... That was in the cable days,...
Bump...I sold my 86 VFR700. However, I still have the 750 engine I've been working on. I'm porting and polishing the head and trying to figure...
No complaints, Vtec bothers me not! :) Road it in this morning...bit cold, 39 degrees! Bike ran fine, put my hippohands on the bars, but it...
Separate names with a comma.
