VF1000F/R Cylinder Boring

Discussion in 'Mechanics Garage' started by DonR, Jan 28, 2019.

  1. DonR

    DonR New Member

    Country:
    Australia
    Joined:
    May 10, 2017
    Messages:
    14
    Likes Received:
    5
    Trophy Points:
    3
    Location:
    Sydney, Australia
    Map
    Hi guys,

    Those of you that have had your liners re-bored, did you remove them for machining or had them machined still installed in the block? If you had the choice, which is the better/more accurate method?

    Regards,

    Don
     
    DonR, Jan 28, 2019
    #1
  2. Thumbs

    Thumbs Member

    Country:
    United Kingdom
    Joined:
    Jun 12, 2015
    Messages:
    1,601
    Likes Received:
    1,103
    Trophy Points:
    143
    Location:
    Bath(ish)
    Cylinder blocks are line bored and honed

    Out the motor
     
    Thumbs, Feb 8, 2019
    #2

Share This Page