Stock Bar End Weight Damper Part Number ?

Did a search and could not find it.


I just ordered a set of Helibars and after reading the install threads about how much a PITA it is to get out the bar end weight dampers from the stock bars, I figure I'll just order brand new ones and avoid the cursing and throwing of tools.

Does anybody have the part numbers for them and a place to buy them from for a good price ?

TIA

 

Have a look at this site. The part numbers are Lings own, not Honda, but if you add to basket it converts to a Honda number. If you poke the retainer ring tab with a screwdriver it should snap off and allow the inner weight to come out. All you should need to do is replace the snap ring rather than the whole weight when re-assembling.

http://www.lingshondaparts.com/hond...__0700&block_03=5923&block_04=xx&block_05=hmc

 

Thank's for the help, ordered some the other day.

 

Mine were no big deal to get off. Spray some WD40, push the pin in, and twist them out. Took about 5 minutes for one and 2 minutes for the other one. But I replaced them with Vibranators and they came out easy that time too.

 

Wow, those are some pretty steep prices. I looked at Bike Bandit, which is usually fairly high, and they were half the price of LingsHondaParts.

 

Could of had mine for the cost of shipping. I replaced them with internal bar/grip heaters when I installed the Heli bars.

 

Well where were you a week ago before I ordered mine ? :ambivalence: lol


How about that RWB 6th Gen of yours for the cost of shipping ? :thumbsup: