Looking for a machinist to do engine work in Australia.

Discussion in 'Mechanics Garage' started by Xenocatalyst, Jun 20, 2017.

  1. Xenocatalyst

    Xenocatalyst New Member

    Country:
    Australia
    Joined:
    Sep 27, 2016
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    1
    Hi Everyone,

    I'm looking for a reputable engine reconditioner/ machinist in australia, preferably NSW or ACT, that could do the bottom end work on my 84 VF1000F engine.

    At the bare minimum it would require big ends and journals machined and new bearings fitted.
    It'd be nice to find someone who is familiar with these engines.
    Anyone have any suggestions?
     
    Xenocatalyst, Jun 20, 2017


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. squirrelman

    squirrelman Member

    Country:
    United States
    Joined:
    Jul 27, 2006
    Messages:
    10,185
    Likes Received:
    877
    Trophy Points:
    128
    Location:
    Buffalo, NY
    Map
    If Honda didn't make larger diameter bearings to go with an undercut crank, machining won't help. Best suggestion is to find a newer bike !
     
    squirrelman, Jun 20, 2017


    This site may contain affiliate links for which VFRworld may be compensated
    #2

Share This Page