2004 Dashboard Resetting

Discussion in 'Mechanics Garage' started by zenjim, Jun 13, 2012.

  1. zenjim

    zenjim New Member

    Joined:
    Apr 6, 2012
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    0
    When the bike is off, no key in the ignition, you can see the clock and the outline of other parts of the LED dash. At random times, the trip meter and the clock will reset. Judging by the time on the clock, I parked my bike at 8 am, went to get on it at 5 pm and it had reset at about 10 am. It's like the battery is dying randomly.
    All recalls have been done including the wiring harness.
    Any ideas?


    Thanks
     


    This site may contain affiliate links for which VFRworld may be compensated
    #1
  2. jethro911

    jethro911 Member

    Country:
    United States
    Joined:
    Feb 8, 2006
    Messages:
    1,994
    Likes Received:
    54
    Trophy Points:
    63
    Location:
    Merrickville, Ontario Canada
    Map
    I had similar symptoms when my RR was on the blink. I fear that this may be your issue also.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #2
  3. zenjim

    zenjim New Member

    Joined:
    Apr 6, 2012
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    0
    RR?
    I fear that I may not know what that stands for.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #3
  4. kennybobby

    kennybobby New Member

    Country:
    United States
    Joined:
    Jul 24, 2011
    Messages:
    909
    Likes Received:
    5
    Trophy Points:
    18
    Location:
    Heart of Dixie Georgia Boys mighta been usin' dat
    Map
    Rectifier/(voltage) Regulator. It converts the AC voltage from the alternator to DC.

    here's what i have found. The power supply to the clock uses these little slide clip leads like what you see inside your computer--cheesy cheap sliding electrical contacts that vibrate, stretch and become loose over time and mileage. You can replace the contacts for a temporary fix, or just solder them and fix it forever.

    A sliding electrical contact will eventually become a problem no matter where it is used, and should be avoided whenever possible, especially for critical applications.
     


    This site may contain affiliate links for which VFRworld may be compensated
    #4
  5. zenjim

    zenjim New Member

    Joined:
    Apr 6, 2012
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    0
    That makes sense.
    I'll take a look.

    Thanks!
     


    This site may contain affiliate links for which VFRworld may be compensated
    #5
Related Topics

Share This Page