It's alive and I get a steady 14.2V so the charging system is solid.
It is definitely a damaged pin locator. That is my next fix for sure. I changed over to a mosfet reg/rec and pulled it out of the harness so...
Fixed!! After all this time it was just a loose W/Y wire in the black connector to the ECM. It was pushing away just a little every time I...
I have replaced the IPG and still no spark. I used an oscilloscope to make sure I was getting a signal out of the IPG while cranking and I get a...
I also have an ECM code 19 so that would be an IPG issue. I guess that's where I need to focus now.
I am back on this project again after taking a break for a while. I am still having a no spark issue at the plug. Since last time, I have...
I should go and test that the ECM is a dead short with the harness attached. I just checked continuity across all the ECM pins since I couldn't...
I did some more investigating and the red connector on the starter relay was cooking too. The connector for the main 30-amp fuse on the R/Y to...
Hello everyone! I am new here and wanted to share your thoughts on an ECM failure. I just started the resurrection of an abused 2006 VFR800 CA...
Hello everyone! I am excited to start resurrecting an abused 2006 VFR800 CA model.
New 2006 VRF project owner
Separate names with a comma.
