It's been a long time since I have had a hose fail that had not gotten damaged by a blower belt or something. I have found a few that were kinda...
R/R is cheap used, I got one off a wrecked FZ-09 or something. Harness connectors are cheap on Ebay. I'm also running LED headlight bulbs off...
I've read that the tune did not really fix the issue and that it was fatigue related, but I do not think there is really good data. Someone with...
I'm not sure how common the piston issue is yet. Triumphs have a lot going for them, sometimes there are some engineering shortcomings but they...
I've been researching the Tiger 1050 and have one big issue: the cracking pistons, related oil consumption, engine failure, etc. That might be a...
Probably $75 shipped if it'd ship cheaply enough. I'll dig it up and take a pic. Here is a pic from when I bought the bike: [ATTACH]
I have a 2 brothers slip on I took off my 2000 when I bought it. Sounded great but it was a bit loud to light off at 6AM (Howdy neighbor! Top o'...
Sounds like the problem. I suggest the cables go on and then a washer that's not oversized in the ID, then any connectors on top of that, also...
I had that exact problem after fitting a battery tender cable with oversized loop connectors on it, that reduced the surface area of the...
Clock going out is generally a loose battery cable.
Good advice so far. I second that it might be sticky rings, a good ride with quality fuel and maybe techron-type cleaner if you can get it might...
What's not lining up? My 2000's front wheel is within 1mm of centered between the fork legs and the brakes don't drag, that's as far as I went...
This sort of problem is usually loose battery cables. If the bike goes dead, no clock or anything, when you turn on the key is often the...
There might be clearance for the fan cooling unit on those LED headlights but I prefer the passive copper braid heat sink on mine. There is not a...
I'm using Buell footpegs, the mounting area needs to be ground a bit to fit but they work well for $45 or so. N0006.1AD Buell Rider Footpeg (Pair)...
There is no adjustment but my 2000 is sensitive to the clutch being bled completely and carefully. You are correct that a worn clutch is an...
Does your tach bounce when you crank the bike? If not then maybe the ECM or the crank sensors. A DMM should show the pulses from the crank...
Sounds like the bolt has stretched or something.
The ECU might run fine at a lower voltage but the physics of lifting an injector pintle against the fuel pressure with less energy might matter.
If you crank it just short of starting and immediately pull a plug, is it wet and smell like gas? I'm not sure if injectors can be lazy and not...
Separate names with a comma.