Thanks for the info. Same as you, will not cut the fairings.
Yes I have a 4th Gen ('97), could you send me a pic or more details as to this ls1 superbike bar kit.
Listed on ebay as "Universal Handle Bar Riser For 41mm Fork Honda VFR 750 800 VTR1000 CBR 600 1000F"
Was wondering if anyone here has tried these? Did they fit? I know that the bar ends will contact the windscreen with these on. Just thinking...
Hopefully the missing small vent tube O ring was the cause of the strong fuel smell....although since the small vent tubes are open to...
I replaced the fuel and vent O rings, found one small vent tube O ring was not there. The intake boots were more like plastic than rubber, so they...
I removed one O ring each of the three sizes....none of them cracked. The large vent O rings are the most squashed ones, look more like a square...
Quick update here: carbs are off and I just separated the two halves. All vents and fuel tube came out very easily.....too easily I think.... I...
What other O ring sizes should I get for the carbs since I am putting an order together?
I sure hope this is a small issue that can be addressed.... By float bowl O-ring do you mean the formed one between the carb body and bowl? If...
I only mentioned the fuel petcock not shutting fuel off 100% as a problem in removing the tank with a lot of fuel in it as fuel would dribble all...
Nope, ,you have them correct, the parts description is incorrect; #4 & #8 are the SM vent tubes and #9 are the fuel tubes. And yes...that bent...
What confused me is that for #4 &# 8 the part description has "Joint Set, Fuel" and #9 just has "Joint Set". I am going to take your advice,...
Capt - need a favor; could you take a look at the carburetor assy diagram for a '97 at the partzilla.com site; it seems to me that fuel tubes in...
Today took the VFR out for a bit, got engine to temp, returned to garage and once again began checking for any drips or wetness under the...
Yep, I know of the ebay seller, have purchased previously purchased from him for another Honda I had. The set of two aluminum tube with O rings is...
I ran the engine today and looked for drips...did not see any, did not go for a ride, just idle and holding at about 2k RPMs. After about 10 min,...
I have been thinking about this more.....I think what is happening is that when I stop, the hot engine below the fuel tank is vaporizing some fuel...
New plugs were installed at just under 35k mikes, currently at 40300 miles. Now time-wise....plugs were replaced in July of 2019. Plan is to...
I have not had the tank off for probably two years now....that was when I put the Stage 1 jet kit in. The strong smell was there before I did the...
Separate names with a comma.