The squirrel is right on here. Clean them again and set the mix screws to the initial setting, check your Honda service manual for the setting....
Wow! Gonna be one heck of an adventure! What bike are you taking? Will you post a pic of it all loaded up and ready to go before you take off...
That's another cause for the twist I've considered.....because everyone is going to use the passenger handle to get the bike on the centerstand....
Allyance, my tailpiece is also higher on the left, over the brake light, when viewed from the rear. I've seen the same thing in pics of other...
My 1st gen 700 is actually a turbine engine, since both use air and fuel and have spinny bits inside. Wirl wirl wirrrlllll!!!! Whoossshhhh!!!
The 5W40 Rotella will be a little thinner at startup but at operating temp should be exactly the same as the 10W40.
https://www.youtube.com/watch?v=lv0a_ybZ8zQ Nailed it! Be sure to watch until the end, you don't want to miss his salute to Honda for the...
Wouldn't hurt to have a new set stashed away. I just made the switch to DOT5 in the rear brakes, did the fronts back in October and so far they...
lucky...send some my way please.
Wait...4 parts in all for $10 correct? 2 seals and 2 wipers?
http://www.motorcycleroads.com/75/555/Texas/The-Three-Sisters-(AKA-The-Twisted-Sisters)--Ranch-Roads-335-336337a.html This???
Wow, do you guys living up in the hill country know how good you have it? We went camping in Bergheim over July 4th weekend, on the drive up I...
http://www.carlparker.com/how2/V4tensioners.html
You're not going to make me jealous of the deal you got....I did really well on mine also :triumphant: .....here's a thread with pics of mine......
Pics of the newly acquired '83 or it didn't happen! ;-) $1,200 is a lot to spend, that's why I want to know if it's a good fix. So far my cams...
Looking good! Full lower fairing....hmmm.....would that fit my '84 700? Does it really do anything other than keep the engine a little warmer?
Mixture screws? That's what I usually hear them referred to as. But the book calls them pilot screws. How did you adjust them? My manual says...
crickets......
I'm a kick stand dismount filler. Here in Texas we had the boot thing but I've noticed they are gone now. What a PITA for bikes and older...
How the heck do I get to the port for the #3 (right, rear) cylinder? It's behind the thermostat housing and engine mount plate. It looks like a...
Separate names with a comma.