Ghost, those polished headers and black side cover look EXCELLENT, Nice bike!
Ally, Could you send me the link of where you bought the rubbers? And I've made some headway on the coolant. I filed the radiator cap...
Bump, anyone?
As far as cleaning the tank, use nuts, bolts, ball bearings, whatever and phosphoric acid. Most other rust eating compounds will flash rust after...
Excellent! It's always nice to hear of another old machine firing up. I don't think you're planning on pulling the carbs apart and cleaning them....
Hello, I am looking at getting a new head gasket for my 1983 VF750F. I would like to get a copper one, but Lani at Copper Gaskets Unlimited...
I ran a compression test previously, most cylinders were within 1-2 psi of 168, the Right front was at 172. I know that's a few pounds low but...
Ok, So I've had her out 4-5 times this weekend, and whenever I get on her hard she blows coolant out the radiator cap. I pretty much gotta keep...
The grease would have helped, it was loose carb boots. A quick spray on any cylinder boot gave a 1krpm jump. So I spun them down until the clamps...
Grey, I'll fiddle withe the pilot screws like planned. Do you think if I sprayed ether/gasoline into the air around the boots I could check for...
Installed the new fuel tubes, Bench synced the carbs because I found one cylinder to be open 1/8" more than the others. Now she's not running so...
Mikey, I would spray the gasoline into the air filter box. You can access it as NormK described above.
You can use gasoline in a windex bottle to see if it will run, I like that better than ether because ether/starting fluid breaks down your oil...
Allyance, She has some nice looking upgrades on her already though, did you do anything to your suspension? -Arrmon
[ATTACH][ATTACH] And that's how she sits now, runs on good old dino fuel now! So the pilot jets were totally clogged, And any first gen lovers...
Ok, more fun stuff. I had this bike at a shop for a few months, they didn't fix anything, just broke my starter gear boss on my engine, and...
Yeah, I got the bike for $250 because the shift spring was broken and NLA. I bought one for 1.68 from a hardware store. The clutch plates were...
Get ready for a necro post, I finally got the bike running! The PO must have rebuilt the starter clutch/signal wheel. I found it to be 120 degrees...
Get ready for a necro post, I finally got the stupid bike running! The PO must have rebuilt the starter clutch/signal wheel. I found it to be 120...
Ok, I adjusted the gap on the pulse generators from .033 to .012. This made a decent change in that the Tach actually moves now, it will jump up...
Separate names with a comma.