Worked great. You get very little gas at the diaphragm unless you turn it upside down. Mostly all you get is a little vapor. I've talked to...
update. Haven't been on in a bit. I pulled the carbs back down, again. The springs were in the correct order, but the needles were not. While I...
Well, rode her to work today, ran pretty good. A little flat due to the 122 jets but man what a difference. I work next door to Napa so I went...
Put it back together today. Cranked easier than it ever has. Took off down the road. Runs a lot better. It is pulling through 7000 now. Gonna...
Tore into them again today. The springs were in the right spots, but the needles were switched. I put the 122 jets back in after the guy at...
Didn't know that. I took them down one at a time and kept everything seperated. B ut the previous owner could have done any number of things
Just spent 20 minutes on the phone with factory pro. Very helpfull guys. I think I blew his mind a little with this on tho. He mentioned that even...
saw the vc cleaner thing on youtube. may give it a try
I've sprayed carb leaner on the carb boots while idling, nothing. Has a regular petcock so no line goin there
That may be a sync issue then.
K I would assume then that this would change the rate that it goes back to idle then? it's kinda slo in that department too.
Was thinking about trying a gravity feed to make sure the pump isn't taking a dump. I took the fuel line off the carbs when I first started...
Checked twice.
I sprayed the boots with carb cleaner, no change in idle. I took one of the rubber air horns off the box and taped up the hole, didn't change. 1/4...
Checked the slides already. there non molested. I read the post, it basically went over the same thing I went through when I put aftermarket...
Cam timing and valve adjustment is right, changed from 122 to 135 on the jets thinking it would go way rich, didn't change. Will check out the...
Haven't checked compression, plugs are a little sooty, but it a little rich at idle, not enough to stall. Sync shouldn't affect revving or...
North Georgia
Just wondering if I'm on the right track here. My 83 vf750f I just traded for has carb issues. I've cleaned them (one at a time, important later)...
The patched diaphragms are on the carbs that seem to be working fine. Gonna tear it back down. At least these bikes are easy to work on
Separate names with a comma.
