Next to the Main and Slow Jets, there is a "starter" jet. It can be called many different things, but it is the press-fit tube next to them....
Since it is to be replaced, take a chisel and a hammer towards the edge and start at steep angle. As it drives in, start vectoring lefty-loosey....
[ATTACH] Also consider removing the limiting collars between the tangs on the clamps. At the very least, verify when you go to install the first...
Some grips are designed to go over that ridge. I will often eliminate it so I can snug any grip up to the housing at the gap I want. My 92 VFR I...
I absolutely would fill and sand, that's pretty bad. Wire wheel back down to alum before applying. You can smooth after applying with a gloved...
I don't believe this is a synch issue. And you don't have to be "blazing any twisties" to desire/require good runability. It's actually a safety...
I'm on the lookout for a nice aluminum double clamp. One loop to attach to the subframe above the exhaust mount and one loop for the brake line...
Unfortunately, he has already done that. Twice I think. So the desire to try and "tune it out" and/or hope it gets better is high. Something is...
Just a couple doo-dads to finish up. Still have a brake side wheel dust seal to install. Be here at the end of the week. Thought for sure I had...
Thank you both. I'm pretty enamored. Can't wait to roll out in the sun... and eventually ride it again.
And a starter Upgrade Kit for a stock VFR... [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] The colors are way off in here and it's cramped, but it was dark and cold by the time I got...
Some bikes the idle adjuster isn't very accessible, like the 500. It sucks actually. I don't set my bikes up to where I have to jockey on the...
A 500 should pull away from a stop very smoothly and linearly, with little effort. Not much finesse or technique should be needed. WD, I really...
Very good. Enjoy when the weather warms up and give us a ride report. I am REALLY ready for some moto time myself.
Will likely be ok. I am still of the opinion it happened sometime the cover was off, it seems the only way the pin could be forced off center and...
Someone without long screwdrivers.
You can (want to) do it with the carbs in? EDIT: Just read "nearly ready"
The pic of your bike convinced me I would like it.
It's gonna be weird at first.
Separate names with a comma.
