Guess I will let that one go. I am not feeling I want to go that deep into restoraton. I want get the bike to run again.
I am looking to replace Left side tank Winged Honda Decal this link is to a not available example at CMS in theNeterlands...
Thanks for the tip again! Yes removed and cleaned. By the way I don't recommend putting Gumout in an ultrasonic degreaser!!!! Unless you like...
I was confused, probably from the smell of various volatile solvents in my garage? I am talking about Synchro screws. I did not touch the...
Is there any home brew Pilot Screw Adjusting ideas that don't cost a rediculous amount of money. I can smell the finish line, no not really.
Going to look at Autozone today for some preformed stuff off the rack? I ordered some 1 mm x 12mm long cotter pins to replace the linkage pins...
Speaking of vacuum, I have noticed that the hoses for my carbs are extremely hard, and one has a split where it slides on to the plastic tubing....
I ordered 50 x 3 mm Viton Orings. at https://www.oringsandmore.com/ For information sake anyone in the Metro Denver area can walk in to...
Plenum orings look like they should be 50 x 3mm? going to see what I can find before I head out on the KLR for morning stroll here in Colorado...
Nope. I assume there is supposed to be something there hence the ring grooves/lans? I will attempt to figure out what size to order. Had...
did not have any orings at the air box to intake lans when I took it apart. Sizes if required? they look like they should have been pretty fat?
The washer still stops at the collar. It kind of sits in a little groove between the oring and the end of the tube. It is nearly impossible to...
Oh Capt 80's wanted to say special thanks for the tip and link for orings. I re-assembled number 1 yesterday and the 73mm bowl ring was...
[ATTACH] [ATTACH] The images are of the transfer tube between 1 and 2. I lost one of the really thin rings that you see on the first image. It...
Yuh, the slides come pretty clean, but I haven't gotten to number 3 yet, the bad one. I did separate the mains from the holders on 1, and 2....
[ATTACH] Acknowledged. Check out the black tar on the slow and main holder. I have them bubbling in an ultra-sonic bath right now. I got...
I am back home and hoping to get into the carbs again. Got some .25 mm wire to push through the enrichment valve. I will break down 2-4 and do...
Found and ultrasonic degreaser, nothing fancy but functioning well.. Lots of gunk came out of Main holder and slow jet. Enrichment valve area is...
On carb one I removed the Main jet holder and the Slow jet and ran the smallest wire I had into the Enrichment tube. All things were gummy! Very...
So bout to get into to tonights carb exercises. Wanted to ask if there was any reason to remove the needles from the slides? I was able to get...
Separate names with a comma.
