that is for uamps setting, omega is for ohms, do a quick search it will give you a picture or this link http://en.wikipedia.org/wiki/Ohm
not for that year, most likely wiring as squirrel stated
wow I have never seen a green vfr
I do not have my prints handy, but is it a two wire temp sensor, if so measure ohms from ground side to frame, key off for this test
does it do it in neutral?
pick up some split wire loom, will fix that mess up
what voltage is at the relay/flasher
i think the connectors were dirty, glad to here you have it fixed
stay with me
we will get it sorted mc
do both sides again, set dmm to dc, your readings are not makinging sense. make sure you have a good ground point for the blaclk lead
and you said the left side worked before right?
did you jumper the relay connection as before and have the ign on
measure and you will know
i am looking at the service manual for it
left is abs model
fuse box right side in front of handle bar
check fuse E
measure with red probe right at sig light to the actual frame, this will eliminate 12vdc wire issue right to the light. if 12 volts you know it is...
with it jumpered, measure voltage to fram ground at front right signal light. if 12v then chase down your ground issue. or jumper the green wire...
Separate names with a comma.
