Wow, I had to make sure this wasn't my bike. I had the exact same 2 issues. I succesfully found the brass part from another carb and fitted it...
If your stock needles were wore out and you weren't sure if the jets in the bike were stock or drilled, do you think a dynojet kit stage 1 would...
Bench syncing is wildly inaccurate. It's to just to let you crank the bike and get it running so you can do an actual sync.
Here you go: http://www.v4market.com/Fuel-Tubes--4-tube-set-for-86-87-VFR700F_p_179.html 2 tubes are for fuel and the other 2 are for venting the...
Mine was broken when I got my bike and it's still broken. A fat washer and screw seems to hold them together just fine. If you have the broken...
This is not quite accurate. The main idle screw only controls the front left carb. The other 3 carbs are connected with linkage. Those 3 can still...
That particular one says for 87-88 bikes. The 86-87 had 37mm forks and the 88-89 had 41mm forks. Even though braces fit onto the lower part of the...
I was hoping there would be talk of modding the VFR for an Ironbutt or just long distance cruising. Any suggestions? I'm thinking: taller...
Are you strapping the bike down to the stand like your supposed to? Also, since the bottom on the bike is not flat, how the heck are you lifting...
The back is easy, just use a small jack on the right side of the center stand/frame mount. I add a 2x4 block under the side stand so it doesn't...
A pair of bolt on risers can be welded on as opposed to bolted. Assuming both pieces are aluminum, of course. On my 86 VFR700 I put a set of...
So it didn't matter if it was near the head or in the back where the 2 to 1 collector was?
Winch and mallet is for single person install. It's easier with a buddy. They can apply downward pressure while you make sure the boots are lined...
Hey Volksmech, I don't know if you are on this forum anymore, but if you are, can you give some details on your wideband install? Like where did...
I completed my kawasaki front end swap. I also have the 88-89 VFR750P handlebars which sits you more upright. I'm loving the corners now. The bike...
I did make sure they were aligned. I think you get into a situation where one corner of the carbs start to push down (front left in my case) and...
I've had a rubber boot lip fold over as I pushed the carbs down. This was with new boots. I used a flashlight and small mirror to inspect the...
Mohawk and Norcalboy, did you see my recent posts or just the 8 month old one? A lot has changed, I did a front end swap. It's no longer scary...
I don't think I am. For instance, increasing rebound on the rear shock or increasing preload can reduce the rear suspension from extending so much...
I figured out why my bike was scary around corners. It wasn't the rear end, it was the front. I swapped the whole front end from a sport bike...
Separate names with a comma.
