Covers are off. Coolant overflow almost empty! Just a small bit near the hose otherwise empty. When I bought the bike 4 months ago it...
Yes the cooling fan comes on. No idea if it does so consistently or turns at the speed it should. Maybe it's just an air pocket in the system. I...
So possible causes: Blocked fins Blocked lines Fan thermostat malfunction Coolant thermostat malfunction Water pump damage? Too little water in...
I'm going to replace the coolant ASAP and try to watch for when the thermostat opens as I do so. Thanks for the tip! I read up on how the...
I hit 251 and the high temp light cracked. Jk but man that's too hot. Anything else I should check? Could it be a bad thermostat?
95 degrees today. Bike hit 241 in traffic. Gotta get that coolant out and refreshed!
I figured it would at least cool the coolant in the radiator and in that way decrease the temp of coolant in the "system". Additionally I figured...
So I left the key on to keep the cooling fan running on my 6th gen after I shut down the motor. Unfortunately this leaves the headlight on and...
I picked up 50/50 Prestone premix. I found the drain plug on the side- but how do I ensure no air bubbles in the system after filling up?
Do I need special honda coolant? Should I put in water wetter? I know to use distilled water 50:50 to coolant right?
My bike hit 238 a few times today riding around in high humidity and mid 90 degree temps. I know the coolant in the overflow tank is at the low...
I've been looking into doing something similar. The cost of custom phone mounts is expensive. Can you please explain how you mounted this to the...
Yup I bought my VFR on the advice of a mechanic too. I don't worry too much because it is a Honda- but thought I saw temp gage hitting 235. I...
What is the highest temp Id ever want to see without deeming it an overheat?
Edit: just read that it's normal as there is only a left side fan... New question: is 235 degrees Fahrenheit a normal operating temp?...
I have the Genmar risers. They are essentially spacers shaped like the cross section of a cam lobe (somewhat egg shaped). The stock vfr bars...
Cool video
It was a smaller headset spanner from a vinyl bagged bicycle repair kit from the 70s. It's funny- all these years shuffling it from one tool box...
Nice video thanks! Also like the one "vfr engine sound explained". I have to take a closer look but I think the fastener simply had a center pin....
I'm asking because I just did:( I'm now scared to ride the bike for fear the rear shock pre-load spanner will either mangle a pivot or wind up in...
Separate names with a comma.
